User guide

VMS Network Configuration
3-28 VMS User Guide
tion and FEC Rate, can occur. Note, however, that Turbo mode should never be
changed.
To configure a roaming remote and different specifications per satellite are
required, perform the following steps. Otherwise, proceed to the next section,
“Pool Management”.
Figure 3-32 S.A.S. tab with SOTM Enabled
9. Right-click in the center of the S.A.S. tab and select Insert to open the Select
Object dialog.
10. Select the Vipersat Bandwidth Manager Service from the list of object
names and click OK.
11. Select the Satellite and click OK, then modify the Modulation and FEC
Rate for the switched SCPC characteristics of this satellite service area.
Note: When switching between satellites, the Modem Extra values set within
the SAS will override the Modem Extra block setting in the Policy tab.
The Home State Extra block setting is not affected, as it is used for
reverting to STDMA mode.
NOTE