User guide

Chapter 3 - Using the Command Line Interface (CLI) 3-45
Vipersat Configuration
Note that this timer setting should be at least three times greater (longer in dura-
tion) than the timer setting at the Hub to ensure that the network link is main-
tained.
ToS Switching Parameters
This menu item appears for Remote modems only.
When ToS switching is enabled on a CDM-570/570L, the parameters for ToS
switching must be defined by entering P from the STDMA/SCPC Auto Switch-
ing screen (see figure 3-41). The TOS Switching Control menu shown in
figure 3-58 is displayed, allowing parameter entry for the desired ToS service to
be applied.
Figure 3-58 ToS Switching Control screen
ToS Switching Entry
After determining what ToS value to use, either application or router classifier,
select a ToS entry from the list for configuration or edit. The screen will prompt
for inputs to the list of range-checked values, as shown in the sample dialog in
figure 3-59 that displays the entries for TOS 03.
Figure 3-59 ToS Switching Entry dialog