User guide

Initial Configuration
2-10 Vipersat CDM-570/570L User Guide
Set the Satellite Modem Configuration
1. Enter M from the Main Menu, then enter C from the Satellite Modem
menu to access the Configuration screen.
2. Enter T to access the Tx Configuration screen shown in figure 2-8. Set
the Tx parameters for Frequency, Data Rate, FEC, Code Rate, and
Modulation as specified by the network administrator.
Note: Only Turbo Product Coding is acceptable for FEC when the CDM-570/
570L
is running in Vipersat mode.
Figure 2-8 Tx Configuration screen
3. Enter R to access the Rx Configuration screen, and set the Rx parameters
as specified by the network administrator.
4. Save the settings to flash by entering S at the command prompt.
Set the Vipersat Configuration
1. Enter V at the Main Menu command prompt shown in figure 2-1 to select
the Vipersat Configuration menu shown in figure 2-9.
NOTE