User guide

Initial Configuration
2-6 Vipersat CDM-570/570L User Guide
Figure 2-5 Working Mode dialog
5. When the reboot is completed, return to the Feature Configuration screen
and configure the settings for Vipersat STDMA and Auto Switching
according to the table below.
6. Save the settings to flash by entering S at the command prompt.
Set the IP Address
1. From the Main Menu, enter I to access the Interface Configuration menu
screen, then enter E to access the Ethernet Interface screen, as shown in
figure 2-6.
Table 2-2 Vipersat Feature Configuration
Unit Role Vipersat STDMA Auto Switching
Hub Enabled (optional) Enabled (optional) Enabled
Hub Expansion Enabled Disabled Disabled
Remote Enabled (optional) Enabled (optional) Enabled
Remote Expansion Enabled Disabled Disabled