Product specifications

CDD-562L/564 Demodulator with IP Module Revision 1
Rear Panel Connector Pinouts MN/CDD564L.IOM
3–4
3.4.2 Async-Serial Console, RJ-11
The Async-Serial EIA-232 DCE Console interfaces the IP Module Command
Line Interface (CLI) and is used for management of demodulator and IP Module
functions using a terminal emulator connected to the Console port via the
supplied adapter cable. The Serial Console Connector is a standard 6-pin RJ-11
modular jack. Observe the following:
Pin # Function
1 Ground
2 Rx
3 Tx
4 Ground
5 Not used
6 Not used
3.5 Power / Ground Connections
3.5.1 Alternating Current (AC) Power Connector (Standard)
A standard, detachable, non-locking, 3-prong power cord (IEC
plug) supplies the Alternating Current (AC) power to the
demodulator. The IEC line input connector contains the
ON/OFF switch for the unit. It also is fitted with two fuses, one
each for line and neutral connections (or L1, L2, where
appropriate). These are contained within the body of the connector, behind a small plastic flap.
Observe the following:
AC Power Specifications
Input Power 40W maximum, 20W typical
Input Voltage
100 - 240 volts AC, +6%/-10% - autosensing
(total absolute max. range is 90 - 254 volts AC)
Connector Type IEC
Fuse Protection
T3.15A Slow-blow (for 120/230 volt AC operation)
Line and neutral fusing
20 mm type fuses
IMPORTANT
For continued operator safety, always replace the fuses with the correct type
and rating.