Product specifications

CDD-562L/564 Demodulator with IP Module Revision 1
Introduction MN/CDD564L.IOM
1–8
1.3.5.2 Rear Panel
Figure 1-7. Rear Panel Views
Figure 1-7
shows the rear panels of the demodulators. External cables are attached to connectors on
the rear panel of the unit.
Each connector is described in detail in Chapter 3. REAR PANEL CONNECTOR PINOUTS.
They comprise:
Connector Group
(Chapter 3 Sect.
Ref.)
Name
Connector Type
Function
CDD-562L
(L-Band)
CDD-564
(70/140 MHz)
CDD-564L
(L-Band)
IF
(Sect. 3.2)
Rx 1 (Rx A on
CDD-564L)
Type ’N’ female BNC female Type ’N’ female
IF Input
Rx 2 (Rx B on
CDD-564L)
Type ’N’ female BNC female Type ’N’ female
Rx 3 (Rx C on
CDD-564L)
N/A BNC female Type ’N’ female
Rx 4 (Rx D on
CDD-564L)
N/A BNC female Type ’N’ female
Terrestrial Data
(Sect. 3.3)
10/100 Ethernet RJ-45 female Ethernet Traffic
Console RJ-11 female
A
sync Serial Console Port
Utility
(Sect. 3.4)
Remote Control 9-pin Type ‘D’ male
Remote Interface (EI
A
-232) for
Factory Test
Power/Ground
(Sect 3.5)
A
C See Sect. 3.5.1
Chassis power
DC (Optional) See Sect. 3.5.2
Ground #10-32 stud Common Chassis Ground
The European EMC Directive (EN55022, EN50082-1) requires using properly
shielded cables for DATA I/O. These cables must be double-shielded from end-
to-end, ensuring a continuous ground shield.
NOTE
CDD-562L
CDD-564
CDD-564L