Product specifications

CDD-562L/564 Demodulator with IP Module Revision 1
Web Server Interface MN/CDD564L.IOM
8–33
8.2.7.2 Maint | Operations
Figure 8-26. Maint | Operations page
Use the ‘Maint | Operations’ page (Figure 8-26) to
configure the unit’s handling of firmware
upon boot-up:
Boot/Upgrade Image
• Boot From: Determines which firmware version (includes Application, FPGA, and
FFPGA) will be loaded upon boot-up. Using the drop-down menu, click on Latest (boots
the newest firmware load based upon date), Image1 (boots the firmware loaded into the
first slot in permanent storage), or Image2 (boots the firmware loaded into the second
slot in permanent storage).
• Upgrade To: Determines which installed firmware (includes Application, FPGA, and
FFPGA) that the demodulator will overwrite when upgrading with a new firmware
download. Using the drop-down menu, click on Oldest (overwrites the oldest firmware
based upon date), Image1 (overwrites the firmware loaded into the first slot in permanent
storage), or Image2 (overwrites the firmware loaded into the second slot in permanent
storage).
Parameter Image
Using the drop-down menu, select one of the following:
• None – No deviation from the parameter currently saved to Flash.
• Save Parameters to Flash – When changes are made to the demodulator’s parameters,
the ‘Maint | Save’ page must be selected in order for these settings to be valid through a
power cycle. Without using this option, settings will revert back to their previous state as
indicated by the last time changes were saved to Flash memory.
• Load Parameters from Flash – Reloads the parameters from Flash memory. This may
overwrite changes that have not yet been saved to Flash memory.
• Restore Factory Defaults – uses the internal, hard-coded factory default parameters.
Note: Restoring the factory default configuration requires a system reboot.