User guide

Chapter 3 - Using the Command Line Interface (CLI) 3-47
Vipersat Configuration
Figure 3-60 Receive Coding Rate prompt
Note that Coding Rate 6 (1/1) is not a valid selection when operating in Vipersat
mode with Turbo Product Coding.
Receive Modulation Type
Enter Q to use the dialog shown in figure 3-61 to set the Receive Modulation
Type for the selected Demod’s Home State.
Figure 3-61 Receive Modulation Type prompt
Vipersat Summary
The Vipersat Summary screen can be viewed by entering D at the command
prompt in the Vipersat Configuration screen (figure 3-6).