User guide

Chapter 3 - Using the Command Line Interface (CLI) 3-25
Vipersat Configuration
Figure 3-30 Enable/Disable Remote prompt
Enter the number of the Remote at the command prompt to toggle the Remote
from its current Enable/Disable configuration.
In the example screen shown above, both Remotes 1 and 2 are Enabled.
View Remote(s)
Entering V at the command prompt shown in figure 3-20 will display the listing
of Remote(s) that belong to the STDMA group for this Hub burst controller, and
their status, as shown in figure 3-31.
Figure 3-31 View Remote(s) screen
The display is for information only and pressing any key will return the screen
to the menu shown in figure 3-20.
Remove Timeout
Entering R at the command prompt shown in figure 3-20 will display the
Remove Timeout dialog shown in figure 3-32. Note that this menu item shows
the current setting (in seconds) for this parameter.