User guide

Vipersat Configuration
3-24 Vipersat CDD-56X Series User Guide
Figure 3-27 Global SCPC Data Rate prompt
Similarly, the Global Switch Type command can be used to set the switch type
for all or a majority of the Remotes. Enter H at the command prompt.
Figure 3-28 Global Switch Type prompt
Delete Remote
Entering D at the command prompt shown in figure 3-20 brings up the Delete
Remote dialog shown in figure 3-29.
Figure 3-29 Delete Remote prompt
Enter the number of the Remote CDD-56X at the command prompt to delete it
from the STDMA group for this Hub burst controller.
Enable/Disable Remote
Enter E at the command prompt in figure 3-20 to display the dialog shown in
figure 3-30. The Remotes in the network are displayed, indicating whether each
is currently Enabled (E) or Disabled.