User guide

Chapter 2 - Quick Start Configuration 2-9
Initial Configuration
Figure 2-7 Configuring the Route Table screen
In a Hub configuration, the default gateway will typically point to a router on
the same LAN as the CDD-56X Hub unit.
In a Remote configuration, the default route will typically point to the satellite
modem used for communications back to the Hub.
3. When prompted, enter the Route Name (GW), the IP Address, the
Number of Bits in the subnet mask, the Route Interface (Ethernet or Sat-
ellite), and the Next Hop address. The system administrator can supply
this information, if necessary.
In a Hub role, for example, enter the name of the route (e.g., GW), enter
0.0.0.0 for the destination IP address and 0 for the mask, enter E for
Ethernet interface, then enter the IP address of the appropriate router or
modem for the next hop.
4. Enter S at the command prompt in figure 2-7 to save the settings to flash.
Set the Satellite Demod Configuration
1. Enter M from the Main Menu, then enter C from the Satellite
Demodulator menu to access the Configuration screen.