User guide

Vi per sat C o nf igu rat ion MN/22137, rev 1
3-26 Vipersat CDD-56X Series User Guide
Switching feature Enabled (see the section “STDMA/SCPC Automatic Switch-
ing” on page 3-32).
Figure 3-29 Remote SCPC Data Rate prompt
The Global SCPC Rate command can be used to set the data rate for all or a
majority of the Remotes. This allows the rate to be entered just once instead of
entering the rate for each Remote individually. Enter G at the command prompt
in figure 3-28.
Figure 3-30 Global SCPC Data Rate prompt
Similarly, the Global Switch Type command can be used to set the switch type
for all or a majority of the Remotes. Enter H at the command prompt.
Figure 3-31 Global Switch Type prompt
Delete Remote
Entering D at the command prompt shown in figure 3-23 brings up the Delete
Remote dialog shown in figure 3-32.