Product specifications

UT-4500A Series Upconverters Revision 0
Introduction MN-UT4500A
1–10
1.4.2 UT-4505/E-A, /F-A /G-A, /H-A, /J-A Upconverters
Characteristic Specification
Frequency Range UT-4505-A See Sect. 1.4.1
UT-4505/E-A 6725-7025 MHz
UT-4505/F-A 6425-6725 MHz
UT-4505/G-A 5925-6725 MHz
UT-4505/H-A 5850-6650 MHz
UT-4505/J-A 7025-7075 MHz
Conversion Dual, No Inversion
Step Size 125 kHz standard, 1kHz optional
Preset Channels 32 Frequencies and Gains
Stability over Time ± 1 x 10
-9
/Day
Stability over Temp ± 1 x 10
-8
0-50°C (32-122°F)
IF Input Noise Figure 11 dB Maximum at 0 dB Attenuation
Level -45 dBm Typical
Range 52 to 88 or 104 to 176 MHz (optional 50-80 MHz or 100-180 MHz – see *Note)
Impedance
50" or 75"
Return Loss 23 dB min. with IO Module of Switch Module
RF Output Output Level +17 dBm at 1 dB Compression
Intermodulation -60 dBc @ 0 dBm Output SCL
Carrier Mute -70 dBc
Non-carrier Spurious -80 dBm
Carrier Spurious -65 dBc @ 0 dBm Output
AM to PM 0.1
o
. / dB at –5 dBm Out
Return Loss 20 dB Minimum with IO Module
18 dB Minimum with Switch Module
Impedance
50"
Transfer Gain 35 dB ± 2 dB
Gain Adjust 0-25 in 0.25 dB Steps
0.1 dB Steps Optional
Gain Stability ± 0.25 dB/Day
Ripple 70MHz IFCF: ±0.25 dB (±18 MHz), optional ±20 MHz (see *Note)
140 MHz IFCF: 0.75 dB (±36 MHz), optional ±40 MHz (see *Note)
Slope 0.05 dB/MHz
IF Bandwidth 36 or 72 MHz, optional 40 or 80 MHz (see *Note)
Slope 0.05 dB/MHz
External Reference Input, either 5 or 10 MHz Option @ +3 dBm
Optional 10 MHz Rear Panel Reference Output
Group Delay Linear Group Delay 0.03 ns/MHz
Parabolic Delay 0.01 ns/MHz
2
Group Delay Ripple 1.0 ns Peak-to-Peak
Phase Noise Parameter Limit (dBc/Hz) Typical (dBc/Hz)
100 Hz -69 -72
1 kHz -79 -82
10 kHz -89 -92
100 kHz -99 -102
1 MHz -109 -112