Product specifications

UT-4500A Series Upconverters Revision 0
Introduction MN-UT4500A
1–4
1.2.3 Front Panel
Figure 1-4. UT-4500-A Series Upconverter Front Panel
Figure 1-4 shows the t
ypical front panel of the UT-4500-A Series Upconverters. This example
depicts a UT-4505-A Upconverter. All operator controls, indicators and displays for local and
remote operation are located on the front panel of the UT-4500-A. The front panel features (from
left):
! Two Test Point Sample Ports – The test point connections are used for monitoring the
RF input and the IF output. An SMA connector is provided for the RF output, and a
BNC connector is provided for the IF input. There is also an optional RF LO monitor
available.
! Six Light-Emitting Diode (LED) Indicators – The LEDs indicate, in a summary
fashion, the status of the unit.
! Vacuum Fluorescent Display (VFD) – The VFD is an active display showing two lines
of 24 characters each. Each configuration function, or operating mode, is shown on the
display when the operator enters a command using the keypad.
! Six-button Keypad – The keypad comprises six individual keyswitches. They have a
positive ‘click’ action, which provides tactile feedback.
1.2.4 Rear Panel
Figure 1-5. UT-4500-A Series Upconverter Rear Panel
Figure 1-5 shows the ty
pical rear panel of the UT-4500-A Series Upconverters. This example
depicts a UT-4505-A Upconverter with Transmit Switch Module (TSM) installled. The rear panel
features (from left):
! Prime Power Switch – The on/off prime power switch is located on the rear of the
chassis adjacent to the prime power input connector. The power switch contains a filter
and dual fuse. The dual fuse is rated for 2 Amps.
The UT-4500-A is provided with a six-foot AC power cord.
! Exhaust Fan – The internally mounted exhaust fan vents through the rear panel for
chassis cooling.