Product specifications

UT-4500-A Series Upconverters Revision 0
Appendix A MN-UT4500A
A–24
A.7.7 Command Summaries
A.7.8 User Remote Command Summary
Utility Commands
Set Time <DEV/TIM_hh:mm:ss'cr'
Set Date <DEV/DAT_mm/dd/yy'cr'
Set Local / Remote Status <DEV/LRS_x'cr'
Get MAC Address <DEV/MAC_ 'cr'
Get IP Address <DEV/IPA_'cr'
Get IP Gateway <DEV/IPG_'cr'
Set Physical Address <DEV/SPA_xxx'cr'
Set Baud Rate <DEV/SBR_xxxx'cr'
Set LCD Contrast <DEV/CON_xx'cr'
Set LCD Brightness <DEV/LCD_xx'cr'
Set Screen Saver Mode <DEV/SSM_x'cr'
Set Screen Saver Timeout <DEV/SST_xx'cr'
Set VFD Brightness <DEV/VFD_xxx'cr'
Set Reference Oscillator <DEV/SRO_xxx'cr'
Set Converter Slope Adj. <DEV/SSA_xxx'cr'
Get Equipment Type <DEV/RET_'cr'
Get Part Number <DEV/PNM_'cr'
Get Legacy Firmware Information <DEV/FRW_'cr'
Get Firmware Information <DEV/FRM_'cr'
Set Firmware Image <DEV/IMG_x'cr'
Set Application ID Message <DEV/AID_xxxxx...xxxxx'cr'
Set Force Reboot <DEV/FRB_YES'cr'
Configuration Commands
Set Frequency <DEV/FRE_xxxxx.xxx'cr'
Set Attenuation <DEV/ATT_xx.xx'cr'
Select Cold Start Mode <DEV/CLD_xxx'cr'
Mute/Unmute Converter <DEV/MUT_xxx'cr'
Set Carrier Mute Mode <DEV/CMM_xxx'cr'
Set Redundant Mute Mode <DEV/CRM_xxx'cr'
Set Fault Recovery Mode <DEV/AFR_xxx'cr'
Set a Preset <DEV/PGM_nn_xxxxx.xxx_yy.yy'cr'
Get All Presets <DEV/DPS_'cr'
Clear a Preset <DEV/CLR_nn'cr'
Select a Preset <DEV/SEL_nn'cr'
Redundancy Mode Commands
Select Redundancy ON/OFF <DEV/RED_xxx’cr’
Configure Redundant Converter <DEV/ICT_xx_yy’cr’
Select Auto/Manual Mode <DEV/SAM_xx_y'cr'
Forced Backup Mode <DEV/FBU_xx_y'cr'