Specifications

SDM-300L3 Satellite Modem Revision 0
Index MN/SDM300L3.IOM
i-5
Performance with Noise, Viterbi Encoder, and RS, 15-21
Plesiochronous, 6-13
Plesiochronous Buffer, 10-16
Q
QPSK Decoding, 15-28
QPSK Encoding, 1-8, 15-13
R
Receive Carrier Acquisition Range, 15-25
Receive Carrier Reacquisition, 15-25
Receive DEMUX, 10-16
Receive Doppler/Plesiochronous Buffer Size, 15-28
Receive Frequency, 15-18
Receive Input Power, 15-19, 15-20
Reed-Solomon PCB, 2-6
Reed-Solomon Modes, 5-9
Remote AUPC, 11-6
Remote AUPC:Configuration, 4-69
Remote AUPC:Configuration:AUPC Enabled, 4-70
Remote AUPC:Configuration:B-Band Loop Back, 4-70
Remote AUPC:Configuration:TX 2047 Pattern, 4-71
Remote AUPC:Moniotr:2047 Errors, 4-72
Remote Control, 15-40
Remote Control Operation, A-1
Remote Connector and Pinouts (J6), 3-3
Remote Modem AUPC Configuration and Monitor, 11-6
Response Message Structure (BUC to IDU), 16-3
Revision Emulation, 4-5
RF Input Connector, 3-13
RF Output Connector (CP1), 3-13
RX Clock Jitter, 15-27
RX Clock Phase Adjustment, 15-27
RX Clock Switching due to Failure od Selected Clock, 15-27
RX Clock Data Phase Adjustment, 15-27
S
SDM-300L3 Custom Modem Defaults, 4-118
Scrambling Types, 15-9
Self-Moniotring Local Modem AUPC Control, 11-6
Send Clock Timing Source, 15-26
Specifications, 15-1
Specification Summary, 15-3
Software and Hardware Onstallation/Upgrades, 2-4
Start Character, A-2
Status Commands/Repsonses, A-17
Stored Configurations, 15-41
Stored Faults, 15-41, A-28
Stored FLTS/ALMS:Clear, 4-68
S
tored FLTS/ALMS:Common, 4-67
Stored FLTS/ALMS:Backward Alrms, 4-67
S
tored FLTS/ALMS:Demodulator, 4-65
S
tored FLTS/ALMS:Modulator, 4-65
Stored FLTS/ALMS:Outdoor Unit, 4-68
Stored FLTS/ALMS:TX Interface, 4-66
Stored FLTS/ALMS:Unavailable Seconds, 4-68
Switch Faults, 15-28
System:Boot Firmware, 4-104
System Checkout, 8-1
System Configuration Commands, A-14
System:Demo Mode, 4-105
System:Display Contrast, 4-103
System:EXT AGC:MAX PWR, 4-106
System:EXT AGC:MIN PWR, 4-105
System Faults/Alarms, 9-2
System:FPGA Firmware, 4-105
System:Lamp Test, 4-103
System:Operation Mode, 4-102
System:M&C Firmware, 4-104
System:Master Reset, 4-106
System:Remote Address, 4-101
System:Remote Baud Rate, 4-101
System:Remote Type, 4-101
System:Self Test, 4-103
System Specifications, 15-39
System:Test Mode Status, 4-102
System:Time/Date, 4-100
System:Year Display, 4-102
T
Terrestrial Data Interfaces, 11-7
Terrestrial Interface Types, 15-30
Test Mode, 15-39
Total Buffer Length, 6-14
Transmit Frequency Change Time, 15-11
Transmission Interface, 16-2
Transmitted MUX, 10-15
Turbo Codec Installation, 2-8
Turbo Product Codec, 7-2
Turbo AUPC, 15-35
TX Clock Phase Adjustment, 15-26
TX Clock Switching Due to Failure of Selcted Clock, 15-26
TX Data Phase Adjustment, 15-26
U
Uncoded Operation, 7-5
Unpacking, 2-1, 2-6, 2-8
Utility:Factory Setup, 4-117
Utility:Fixed Modem Rate, 4-73
Utility:Demodulator, 4-82
Utility:Interface, 4-90
Utility:Modem Type, 4-107
Utility:Modulator, 4-74
Utility:Outdoor Unit, 4-99
Utility:System, 4-101