Specifications

SDM-300L3 Satellite Modem Revision 0
Index MN/SDM300L3.IOM
i-3
G
G.703, 13-1, 15-32
G.703 Specifications, 13-1
G.703 T1, E1/ASYNC Interface Adapter, 3-11
General, A-1
Ground Connector (GND), 3-14
H
Hardware Upgrades, 2-14
I
IBS, 10-1, 15-35
IBS Clock and Dejitter, 15-35
IBS Engineering Service CHannel, 15-36
IBS Framing, 15-35
IBS Modem Defaults, 10-5
IBS Primary Data Interfaces, 15-35
IBS Scrambling, 15-36
IBS Specifications, 10-4
IBS Operation, 5-3
IDR, 10-6, 15-37
IDR/IBS G.703 Master.Master, 6-2
IDR/IBS G.703 Master/Slave, 6-2
IDR Engineering Service Channel, 15-38
IDR Framing, 15-38
IDR Modem Defaults, 10-10
IDR Primary Data Interfaces, 15-38
IDR Operation, 5-2
IDR Specifications, 10-9
Implementation, 14-1
Input Overload, 15-18
Installation, 2-2, 2-4, 2-6, 2-8
Introduction, 7-1, 7-2, 10-1, 16-1
Interface:ASYNC TX Baud, 4-41
Interface:ASYNC TX Lerngth, 4-42
Interface:ASYNC TX Parity, 4-44
Interface:ASYNC TX Stop, 4-43
Interface:ASYNC TX Type, 4-96
Interface:ASYNC RX Baud, 4-41
Interface:ASYNC RX Length, 4-42
Interface:ASYNC RX Parity, 4-44
Interface:ASYNC RX Stop, 4-43
Interface:ASYNC RX Type, 4-96
Interface B-Band Loop Back, 4-29
Interface:Buffer Center, 4-32
Interface:Buffer Clock, 4-28
Interface:Buffer Program, 4-92
Interface:Buffer Size, 4-31
Interface Checkout, 8-2
Interface Configuration Commands, A-9
Interface:CTS Delay, 4-98
Interface:Drop Channel Assignments, 4-39
Interface:Drop Format, 4-37
Interface:E1 Insert CRC, 4-94
Interface:EXT-CLK FREQ, 4-27
Interface:Framing Structure, 4-92
Interface:IDR RX ESCT Type, 4-98
Interface:IBS TX ESC Type, 4-98
Interface IDR Backward Alarm Control, 4-95
Interface:IDR TX ESC Type, 4-97
Interface:Insert Channel Assignments, 4-40
Interface:Insert Format, 4-38
Interface:INTRFC Loop Back, 4-30
Interface:Loop Timing, 4-32
Interface:RTS TX-IF CNTRL, 4-93
Interface:RX 2047 Pattern, 4-34
Interface:RX Coding Format, 4-35
Interface:RX Clock Phase, 4-28
Interface:RX Data Fault, 4-33
Interface:RX Data Phase, 4-94
Interface:IDR RX ESC Type, 4-97
Interface:RX Overhead Type, 4-90
Interface:RX TERR Interface, 4-91
Interface:Service Channel Adjust, 4-35
Interface Specification, 15-26
Interface:TX 2047 Pattern, 4-33
Interface:TX Data Fault, 4-32
Interface:TX Data Phase, 4-94
Interface:TX Coding Format, 4-34
Interface:TX Clock Phase, 4-27
Interface:TX Clock Source, 4-26
Interface:TX Overhead Type, 4-90
Interface:TX TERR Interface, 4-91
Interleaver (Reed-Solomon Codec), 15-11
Interoperability Modes, 15-41
L
L-Band Demodulator Specifications, 15-15
L-Band INMARSAT Spurious Emissions, 15-10
L-Band Modulator Specifications, 15-6
L-Band Modulator Specification Summary, 15-4
L-Band ODU Control and Monitor, 15-12
L-Band ODU Reference Signal, 15-12
L-Band ODU Supply Voltage, 15-13
LED Indicators, 4-2
LNB Band Control Control, 15-18
LNB Prime Power, 15-18
LNB Reference Signal, 15-18
Local AUPC:AUPC Enable, 4-45
Local AUPC:Local CL Action, 4-48
Local AUPC:Maximum Power, 4-47
Local AUPC:Minimum Power, 4-46
Local AUPC:Nominal Power, 4-46
Local AUPC:Remote CL ACtion, 4-49
Local AUPC:Target Eb/No, 4-47
Local AUPC:Tracking Rate, 4-48
Loopback Modes, 15-39
Loop Timing Operation, 11-9
M
Main PCB Firmware Chips, 2-14
Message Structure, 16-2, A-2