Specifications

SDM-650B Satellite Modem Remote Control Operation
Rev. 6 B–59
B.2.8.1.5 Interface Configuration Status
The interface configuration status command causes a block of data to be returned by the
addressed modem. The block reflects the current configuration of the interface.
Command: <add/ICS_”cr”
Response: >add/ICS_”cr”
TC_xxx”cr” Transmit Clock (INT/EXT)
RC_xxx”cr” Receive Clock (NRM/INV)
BBL_xxx”cr” Baseband Loopback (ON/OFF)
ILB_xxx”cr” Interface Loopback (ON/OFF)
ICFT_xxxx”cr” Coding Format Transmit
(AMI/HDB3/B6ZS/B8ZS)
ICFR_xxxx”cr” Coding Format Receive
(AMI/HDB3/B6ZS/B8ZS)
TOBR_nnnnn”cr” Transmit Overhead Baud Rate
ROBR_nnnnn”cr” Receive Overhead Baud Rate
OCCL_n”cr” Overhead Channel Character Length
OCSB_n”cr” Overhead Channel Stop Bits
OCP_xxxx”cr” Overhead Channel Parity
(See Note 2) ISP_xxx”cr” Interface Substitution Pattern 2047 (ON/OFF)
(See Note 1) ERF_nnnnn”cr” External Reference Frequency
(See Note 1) BC_xxx”cr” Buffer Clock (INT, EXT, REF, SAT)
(See Note 1) IBS_nnnnnn”cr””lf”] Interface Buffer Size
Notes:
1. Available with buffer support hardware only.
2. Available with AUPC support hardware only.
B.2.8.1.6 AUPC Configuration Status
The AUPC interface configuration status command causes a block of data to be returned
by the addressed modem. The block reflects the current configuration of the interface.
Command: <add/ACS_”cr”
Response: >add/ACS_”cr”
LPC_xxx”cr” Local AUPC Enable (ON/OFF)
NOMP_-nn.n”cr” Nominal Power Value (-5.0 to -30.0)
MINP_-nn.n”cr” Minimum Power Limit (-5.0 to -30.0)
MAXP_-nn.n”cr” Maximum Power Value (-5.0 to -30.0)
ENSP_n.n”cr” E
b
/N
0
Target Set Point (3.2 to 9.7)
MAXT_n.n”cr” Max. Tracking Rate (0.5 to 6.0)
LCL_xxxx”cr” Local Carrier Loss (HOLD, NOM, MAX)
RCL_xxxx”cr” Remote Carrier Loss (HOLD, NOM, MAX)
ISP_xxx”cr””lf”] Interface Substitution Pattern 2047 (ON/OFF)