Specifications

Remote Control Operation SDM-650B Satellite Modem
B–56 Rev. 6
B.2.8.1.2 Modulator/Coder Configuration Program
This command is used by the SMS-658 M:N protection switch to collect information that
is necessary to configure backup modems.
Command: <add/MCP_”cr”
Response: >add/MCP_”cr”
MF_nnn.nnnn”cr” Modulator Frequency
MPO_snn.n”cr” Modulator Power Offset
(See Note 1) LPC_xxx”cr” Local AUPC Enable (ON/OFF)
(See Note 2) MOP_snn.n”cr” Modulator Output Power
MR_nnn_mmmm.m”cr” Modulator Rate
SE_xxx”cr” Scrambler Enable (ON/OFF)
DENC_xxx”cr” Differential Encoder (ON/OFF)
TC_xxx”cr” Transmit Clock (INT/EXT)
BBL_xxx”cr” Baseband Loopback (ON/OFF)
ILB_xxx”cr” Interface Loopback (ON/OFF)
ICFT_xxxx”cr” Coding Format Transmit
(AMI/HDB3/B6ZS/B8ZS)
TOBR_nnnnn”cr” Transmit Overhead Baud Rate
OCCL_n”cr” Overhead Channel Character Length
OCSB_n”cr” Overhead Channel Stop Bits
OCP_xxxx”cr” Overhead Channel Parity
(See Note 1) ISP_xxx”cr” Interface Substitution Pattern 2047 (ON/OFF)
(See Note 1) LPC_xxx”cr” Local AUPC Enable (ON/OFF)
(See Note 1) NOMP_-nn.n”cr” Nominal Power Value (-5.0 to -30.0)
(See Note 1) MINP_-nn.n”cr” Minimum Power Limit (-5.0 to -30.0)
(See Note 1) MAXP_-nn.n”cr” Maximum Power Value (-5.0 to -30.0)
(See Note 1) LCL_xxxx”cr” Local Carrier Loss (HOLD, NOM, MAX)
(See Note 1) RCL_xxxx”cr” Remote Carrier Loss (HOLD, NOM, MAX)
RF_xxx”cr””lf”] RF Output (ON/OFF)
Notes:
1. Available with AUPC support hardware only.
2. Only returned if local AUPC is disabled (OFF).