Specifications

Remote Control SDM-309B Satellite Modem
B-B–10 MN/U-SDM309B Rev. #
4.3.2 External Reference Frequency
Command: <add/ERF_nnnnn”cr”
Response: >add/ERF_nnnnn”cr””lf”]
nnnnn = 8 to 99992 (external reference frequency in KHz, must be a a multiple of 8KHz).
Status Only: <add/ERF_”cr”
Response: >add/ERF_nnnnn”cr””lf”]
4.3.3 Interface Loop-back (ON/OFF)
Command: <add/ILB_xxx”cr” (xxx = ON or OFF)
Response: >add/ILB_xxx”cr””lf”]
Status Only: <add/ILB_”cr”
Response: >add/ILB_xxx”cr””lf”]
4.3.4 Base Band Loop-back (ON/OFF)
Command: <add/BBL_xxx”cr” (xxx = ON or OFF)
Response: >add/BBL_xxx”cr””lf”]
Status Only: <add/BBL_”cr”
Response: >add/BBL_xxx”cr””lf”]
4.3.5 Interface Coding Format Transmit (AMI/HDB3/B8ZS)
Command: <add/ICFT_xxxx”cr” (xxxx = AMI,HDB3 or B8ZS)
Response: >add/ICFT_xxxx”cr””lf”]
Status Only: <add/ICFT_”cr”
Response: >add/ICFT_xxxx”cr””lf”]
4.3.6 Interface Coding Format Receive (AMI/HDB3/B8ZS)
Command: <add/ICFR_xxxx”cr” (xxxx = AMI,HDB3 or B8ZS)
Response: >add/ICFR_xxxx”cr””lf”]
Status Only: <add/ICFR_”cr”
Response: >add/ICFR_xxxx”cr””lf”]
4.3.7 Scrambler Enable (ON/OFF)
Command: <add/SE_xxx”cr” (xxx = ON or OFF)
Response: >add/SE_xxx”cr””lf”]
Status Only: <add/SE_”cr”
Response: >add/SE_xxx”cr””lf”]