Specifications

CiM-550 IP Enabled Satellite Modem Rev. 2
CiM IP Module Checkout & Fault Isolation CD/CIM550.IOM
424
14.2.8 CIM 2 CONFIGURATION
Disconnect RJ-11 end of the console cable from CiM 1 and connect it to CiM 2.
14.2.8.1 SETTING IP ADDRESS(ES)
Step Procedure
1
From the Main Menu select Network Configuration sub-menu.
2
Set Ethernet IP Address to 172.17.10.10.
3
Set Subnet Prefix Length to 24.
4
Set HDLC IP Address to 10.1.1.2.
5
Set RX – Enable/Disable and TX – Enable/Disable to Enable.
6
From Receive HDLC Channel Address menu set HDLC Addr 1 to 1 (0x0001)
The other parameters can be left to their factory default settings. At this point you should
be able to ping CiM 2 from PC 2:
7 ping 172.17.10.10
8 ping 10.1.1.2
14.2.8.2 ROUTE TABLE
Step Procedure
1
From Transmitter Configuration, sub-menu select Route Table sub-menu.
2
Enter 1 to configure the first route
3
Enter a suitable name
4
Set IP Address to 172.16.10.0
5
Set Number of Subnet Bits to 24
6
Enter the next hop IP address which is CiM 1’s HDLC IP Address, 10.1.1.1
14.2.8.3 SAVE CONFIGURATION
Save parameters to permanent storage.
14.2.9 VERIFICATION
At this point the basic configuration is over and you should be able to:
 Ping PC 1 from PC 2 and vice versa
 Ping CiM 2 from PC 1 and vice versa
 Pass any other data between the 2 PCs
If Pings are not successful, refer to section 14.3, Troubleshooting IP Module.