Product specifications

CDM-840 Remote Router Revision 2
Ethernet-based Remote Product Management MN-CDM840
6–2
6.2 Ethernet Management Interface Protocols
The user PC facilitates access to Ethernet-based remote monitor and control (M&C) of the
CDM-840 through two separately-operated protocols:
• Simple Network Management Protocol (SNMP). This non-secure interface requires a user-
supplied Network Management System (NMS) and a user-supplied Management Information
Base (MIB) File Browser.
• The CDM-840 Web Server (HTTP) Interface. This non-secure interface requires a compatible
user-supplied Web browser such as Internet Explorer.
6.2.1 Ethernet Management Interface Access
Access to the CDM-840 Ethernet Management Interface requires you to specify the unit
Management IP Address. This address may be obtained from the CDM-840 Serial Interface,
upon power-up of the unit, via use of a terminal emulator connected with a user-supplied
adapter cable to the 19-pin serial ‘CONSOLE/ REDUNDANCY’ port. As shown, a number of
operational parameters (including the unit factory-default IP addresses) are displayed.
The default (factory-assigned) IP addresses are provided in the table that follows (if otherwise
assigned, you may use the last column to write down the IP addresses for future reference):
Description Default Address User-assigned Address
Management IP Address 192.168.1.12 ____________________________
Traffic | GE (GigE) IP Address 10.10.3.12 ____________________________
See Chapter 7. SERIAL-BASED REMOTE PRODUCT MANAGEMENT for details on
setting up and using the CDM-840 Serial Interface.