Product specifications

CDM-710 Broadcast Satellite Modem Revision 10
Front Panel Operation MN/CDM710.IOM
Rx-Sat (default)
Effectively disables the Rx Buffer because the input and output
clocks are the same. Normally, the Rx Buffer is set for minimum
when Rx-Sat is selected.
Tx-Terr
Uses the clock from the Tx input (TT) to clock out the Rx Buffer.
Internal
Derives a clock from the internal 10 MHz reference clock.
If Intfc1 Rx Clock: Æ Invert is selected:
Intfc1 Rx Clock Invert:
Normal Inverted (efE)
Select Normal or Inverted, using the
◄ ► arrow keys to control clock inversion (added for
compatibility with certain older equipment). The User should then press
ENTER.
If Intfc1 Rx: Æ Enable is selected:
Intfc1 Rx Enable:
Enable Disable (efE)
Select Enable or Disable, using the
◄ ► arrow keys. The User should then press ENTER.
Select Enable to activate the Rx side of this interface. Select Disable to deactivate the Rx side
and set the data rate to 0.
(CONFIG:) Intfc1 HSSI: Æ RTS/CTS
Intfc1 CTS/RTS:
Normal Fault
Select Normal or Fault using the ◄ ► arrow keys. The User should then press ENTER.
Note: CTS is the same as CA, and RTS is the same as TA. The selections operate as follows:
• Normal: CTS = RTS
• Fault: CTS = RTS when no fault is present. CTS is not asserted when a fault is present.
5–30