Product specifications

CDM-710 Broadcast Satellite Modem Revision 10
Front Panel Operation MN/CDM710.IOM
(CONFIG:) Intfc1 ASI: Æ Config
Intfc1 ASI CONFIG:
Port Bandwidth ( E)
Select Port or Bandwidth using the
◄ ► arrow keys. The User should then press ENTER.
If Intfc1 ASI CONFIG: Æ Port is selected:
Intfc1 ASI Port:
J4 J5 ( E)
When J4 or J5 is selected using the
◄ ► arrow keys, it becomes the active port on the ASI
interface. The User should then press
ENTER.
Note: Also see
(CONFIG:) AUX Æ 1:1 Mode for redundancy operation.
If Intfc1 ASI CONFIG: Æ Bandwidth is selected:
Intfc1 ASI Bandwidth:
Wide Narrow (E)
Select Wide or Narrow, using the
◄ ► arrow keys, to select the loop bandwidth of the ASI input.
The User should then press
ENTER.
Wide corresponds to about 2 Hz and Narrow is approximately 0.5 Hz. Normally, the Wide
selection is adequate, but when higher amounts of terrestrial jitter are present in the incoming ASI
data stream the Narrow setting will help reduce jitter. Terrestrial jitter sometimes increases when
data is sent across the Public Switched Telecom Network (PSTN).
5.3.1.5 (CONFIG:) Intfc1 HSSI (CDI-60 HSSI Interface Only)
This menu branch shows what is available if Interface 1(the Interface in Slot 1) is populated with
the CDI-60 HSSI Interface card. The CDM-710 supports a single HSSI Interface (Intfc1).The
menus and submenus depicted in this section are dependent on this installed interface.
Intfc1 HSSI:
Tx Rx CTS/RTS (efE)
There is a single port on a CDI-60 HSSI Interface. Select Tx, Rx or CTS/RTS, using the
◄ ►
arrow keys. The User should then press
ENTER.
5–26