Product specifications

CDM-710 Broadcast Satellite Modem Revision 10

Front Panel Operation MN/CDM710.IOM

5–24

Edit the Eb/No alarm point by selecting the digit to be edited, using the ◄ ► arrow keys. The

Eb/No Alarm: Æ Alarm/Fault is selected:

value of the digit is then changed using the

▲ ▼ arrow keys. The range of values is from 0.1 to

16.0 dB. The User should then press

ENTER.

Eb/No Alarm:

Alarm Fault Mask ( E) 

Select Alarm, Fault, or Masked using the

◄ ► arrow keys. The available choices define the

(CONFIG:) Rx Æ PLL

Eb/No Alarm as an Alarm, as a Fault, or to completely Mask the alarm. This choice affects

operation in 1:1 redundancy. The User should then press

ENTER.

Carrier PLL Bandwidth:

1x 2x (E)

Select 1x or 2x using the

◄ ► arrow keys. The User should then press ENTER. This selection is

5.3.1.4 CONFIG: Intfc1 ASI (CDI-40 ASI Interface Only)

sometimes useful when high phase noise is present. 1x is the normal operating mode.

This menu branch shows what is available if Interface 1(the Interface in Slot 1) is populated with

the CDI-40 ASI Interface card. The ASI interface is available in Slot 1 only. The menus and

submenus depicted in this section allows enabling or disabling of the ASI interface, and are

dependent on this installed interface.

Intfc1 ASI:

Tx Rx Config ( E) 

Select Tx, Rx, or Config using the

◄ ► arrow keys. The User should then press ENTER.

(CONFIG:) Intfc1 ASI: Æ Tx

Intfc1 ASI Tx:

Ena/Dis Frame ( E)

Select Ena/Dis or Frame using the ◄ ► arrow keys. The User should then press

ENTER.