Product specifications

CDM-710 Broadcast Satellite Modem Revision 10
Front Panel Operation MN/CDM710.IOM
If Tx Power Æ Level is selected:
TX Output Power Level:
-10.0 dBm ( E)
Edit the TX Power level by selecting the digit to be edited, using the ◄ ► arrow keys. The value
of the digit is then changed using the
▲ ▼ arrow keys. The User should then press ENTER.
70/140 MHz
0 to -20 dBm
L-Band
-5 to -25 dBm
If TX Power Æ On/Off is selected:
Tx Output State:
Off On ( E)
Select On or Off using the ◄ ► arrow keys. The User should then press
ENTER.
If Tx Power Æ Imped(ance) is selected (this menu selection is available/displayed only when
the 70/140 MHz Modulator card is installed):
TX Impedance (Ohms):
50 75 ( E)
70/140 MHz
Select 50 or 75
Ω
, using the arrow keys, then press ENTER.
L-Band
Not Applicable.
(CONFIG:) Tx Æ Scram
IMPORTANT
The Scam(bler) menu is available only when the Mode selection is DVB-S2.
Tx Scrambling Index:
Gold-n = 000000 (cbE)
The Scrambling menu is active only for DVB-S2 Mode. The Gold-n Index indicates the Physical
Layer spreading sequence number, and can be set from 0 to 262,141. The default setting is all 0s.
Use the ◄ ► arrow keys to select the desired digit. The value of the digit is then changed using
the ▲ ▼ arrow keys. The User should then press
ENTER.
5–18