Product specifications

CDM-710 Broadcast Satellite Modem Revision 10

Front Panel Operation MN/CDM710.IOM

5.3.1 (SELECT:) CONFIG

CONFIG: Remote Tx Rx

Int1 Int2 Ref Aux Alarms

The submenus available are:

Selection

Submenu Description

Remote

(Remote Control) Permits User to define whether the unit is being controlled

locally or remotely. (See Important Note.)

(Transmit) Permits User to define, on a parameter-by-parameter basis, the Tx

configuration of the unit. These submenu branches would be used if the User

wished to change, for example, just the Tx Frequency.

(Receive) Permits User to define, on a parameter-by-parameter basis, the Rx

configuration of the unit. These submenu branches would be used if the User

wished to change, for example, just the Rx Frequency.

Int1

Int2

(Interface) Permits User to configure Interfaces plugged into Slot 1 or Slot 2 on the

back of the unit. The menus change depending on the type of interface – as of this

manual revision, ASI, HSSI, or Gigabit Ethernet (GbE) are available.

Ref

(Reference) Permits selection of the internal 10MHz Reference or allows the

unit to phase lock to an External Reference of 1, 2, 5, 10, or 20 MHz.

Aux

(Auxiliary) Permits User to configure the 1:1 Modem Switching parameters

of the unit.

Alarms

Provides Alarm action of certain parameters.

IMPORTANT

The modem may be monitored over the remote control bus at any time. When

in Local mode, however, configuration parameters may only be changed

through the front panel. Conversely, when in Remote mode, the unit may be

monitored from the front panel, but configuration parameters may only be

changed via the remote control bus.

5–7