Product specifications

CDM-710 Broadcast Satellite Modem Revision 10
Preface MN/CDM710.IOM
Electrical Safety
The CDM-710 Broadcast Satellite Modem has been shown to comply with the following safety
standard:
• EN 60950: Safety of Information Technology Equipment, including electrical
business machines
The equipment is rated for operation over the range 100 to 240 VAC. It has a maximum power
consumption of 60 watts, and draws a maximum of 600 mA.
IMPORTANT
The user should observe the following instructions:
Fuses
The CDM-710 is fitted with two fuses - one each for line and neutral connections. These are
contained within the body of the IEC power inlet connector, behind a small plastic flap.
• For 115 and 230 volt AC operation, use T2.00A, 20mm fuses.
• For 48 VDC operation, use T6.25A, 6.3x32mm fuses.
CAUTION
FOR CONTINUED OPERATOR SAFETY, ALWAYS REPLACE THE FUSES WITH
THE CORRECT TYPE AND RATING.
Environmental
The CDM-710 shall not be operated in an environment where the unit is exposed to extremes of
temperature outside the ambient range 0 to 50°C (32° to 122°F), precipitation, condensation, or
humid atmospheres above 95% RH, altitudes (un-pressurized) greater than 2000 meters,
excessive dust or vibration, flammable gases, corrosive or explosive atmospheres.
Operation in vehicles or other transportable installations that are equipped to provide a stable
environment is permitted. If such vehicles do not provide a stable environment, safety of the
equipment to EN60950 may not be guaranteed.
xiii