Product specifications

CDM-710G High-Speed Satellite Modem Revision 1
Remote Control MN-CDM710G
A–45
[Tx Block] consists of 50 bytes for Transmit configuration. The format is: aaaa.aaaabcc.ccccccdefghhh.hijklmmmmmmnoxxxxxxxxxx
aaaa.aaaa = Tx Frequency (in MHz) same as TFQ
b = Tx Mode (read-only)
cc.cccccc = Tx Symbol Rate same as TSR
d = Tx FEC Type same as TFT (read-only)
e = Tx Modulation type same as TMD
f = Tx FEC Rate same as TCR
g = Tx Spectrum Inversion same as TSI
hhh.h = Tx Power Level same as TPL
i = Tx Carrier State same as TXO
j = Tx Alpha Roll-off same as TAR
k = Tx Frame Size same as TFS
l = Tx Pilots same as TPI
mmmmmm = Tx Gold Code Sequence same as TGS
n = Tx Location of Pilot same as TLP
o = Tx Transport Stream (read-only)
xxxxxxxxxx = Spare bytes.
[Rx Block] consists of 50 bytes for Receive configuration. The format is: aaaa.aaaabcc.ccccccdefggghijkllllllmm.mnopxxxxxxxx
aaaa.aaaa = Rx Frequency (in MHz) same as RFQ
b = Rx Mode (read-only)
cc.cccccc = Rx Symbol Rate same as RSR
d = Rx FEC Type same as RFT (read-only)
e = Rx Modulation Type same as RMD (read-only)
f = Rx FEC Rate same as RCR (read-only)
ggg = Rx Sweep Width same as RSW
h = Rx Adaptive Equalizer same as AEQ
i = Rx Alpha Roll-off same as RAR
j = Rx Frame Size same as RFS (read-only)
k = Rx Pilots same as RPI (read-only)
llllll = Rx Gold Code Sequence same as RGS
mm.m = Rx EbNo Alarm Point same as EBA
n = Rx Transport Stream (read-only)
o=Rx PLL same as RPL
p=Ber Threshold same as BTH
xxxxxxxx = Spare bytes.