Product specifications

CDM-710G High-Speed Satellite Modem Revision 1
Front Panel Operation MN-CDM710G
6–40
6.3.2 SELECT: Monitor
Monitor: Alarms Rx_Stats
Event-Log
Alarms are reported under three main categories:
• Tx path alarms are displayed under the Tx Category
• Rx path alarms are displayed under the Rx Category
• Alarms common to the unit are available under the Unit selection
Refer to Table 6-4 for a lis
ting of alarms.
Select Alarms, Rx_Stats, or Event-Log using the ◄ ► arrow keys, then press
ENTER.
6.3.2.1 (SELECT:) Monitor Æ Alarms
Live Alarms: Transmit
Receive Unit ( E)
Select Transmit, Receive, or Unit using the ◄ ► arrow keys, then press ENTER.
If Live Alarms: Æ Transmit is selected:
TX Traffic: GBEI Card
PHY Not Connected (E)
This will report only if there are modulator errors; otherwise, it will report “No Errors.” Press
ENTER or CLEAR to return to the previous menu.
NOTE: The alarm message depicted in the above example usually indicates that the Ethernet data
cable is disconnected from the modem.
If Live Alarms: Æ Receive is selected:
RX Traffic:
Demod Unlocked (E)
This will report only if Demod is unlocked; otherwise, it will report “No Errors.” Press ENTER
or
CLEAR to return to the previous menu.
If Live Alarms: ÆUnit is selected:
Unit Fault: No Errors
(E)
This will report only if there are unit faults; otherwise, it will report “No Errors.” Press ENTER
or
CLEAR to return to the previous menu.