Product specifications

CDM-710 Broadcast Satellite Modem Revision 11
Front Panel Operation MN/CDM710.IOM
5–30
5.3.1.6 (CONFIG:) Int2 (CDI-70 Gigabit Ethernet Interface Only)
IMPORTANT
Due to limitations of the backplane, the CDM-710 allows only one interface to
be active. For example, if Interface 1 is active, and Interface 2 is then ‘enable
selected’, the unit will automatically disable Interface 2.
Note: The CDM-710 supports a single CDI-70 Gigabit Ethernet Interface (Intfc2), installable in
Slot 2 only; there is a single RJ-45 port on the CDI-70 Gigabit Ethernet Interface. The menu
branch and submenus depicted in this section show what is available when the CDI-70 Gigabit
Ethernet Interface card is installed in Interface Slot 2.
Intfc2 Gigabit Ethernet:
Ingress Egress Man Stats
Select Ingress, Egress, Man, or Stats using the W X arrow keys, then press ENTER.
Note, for the purpose of the documentation of this interface, the following:
• Ingress refers to IP packets received from the LAN
• Egress refers to IP packets transmitted to the LAN
• Transmit refers to MPEG packets transmitted to the WAN
• Receive refers to MPEG packets received from the WAN
(CONFIG: Intfc2 Gigabit Ethernet) Ingress
Intfc2 Gigabit Ingress:
Ena/Dis FEC Str (E)
Select Ena/Dis, FEC, or Str using the ◄ ► arrow keys, then press ENTER.
(CONFIG: Intfc2 Gigabit Ethernet) Ingress Æ Ena/Dis
Intfc2 Ingress Enable:
Enable Disable
Select Enable or Disable using the ◄ ► arrow keys, then press ENTER. Enable is selected for
transmission of the ingress (received from LAN) MPEG-2 transmission stream. Disable is
selected to turn off the MPEG-2 transmission to the WAN.
(CONFIG: Intfc2 Gigabit Ethernet) Ingress Æ FEC
Intfc2 Ingress FEC
Enable Disable
Select Enable or Disable using the ◄ ► arrow keys, then press ENTER. Enable for the GbEI
to perform SMPTE 2022 / Pro-MPEG COP3 error recovery. Disable is selected to bypass
the SMPTE 2022 / Pro-MPEG COP3 function.
Note: SMPTE absorbed the per-MPEG Forum and released SMTE 2022.