Product specifications

CDM-710 Broadcast Satellite Modem Revision 11
Front Panel Operation MN/CDM710.IOM
5–26
5.3.1.5 (CONFIG:) Int1 (CDI-60 HSSI Interface Only)
IMPORTANT
Due to limitations of the backplane,
the CDM-710 allows only one interface to
be active. For example, if Interface 2 is active, and Interface 1 is then enabled/
selected, the unit will automatically
disable Interface 2.
Note: The menu branch and submenus depicted in this section are dependent on the presence
of the CDI-60 HSSI Interface card, installable in Interface Slot 1 only.
Intfc1 HSSI:
Tx Rx CTS/RTS (E)
There is a single port on a CDI-60 HSSI Interface. Select Tx, Rx, or CTS/RTS using the W X
arrow keys, then press
ENTER.
(CONFIG: Intfc1 HSSI) Tx
Intfc1 Tx
Data Clock Enable (E)
Select Data, Clock, or Enable using the W X arrow keys, then press ENTER.
(CONFIG: Intfc1 HSSI) Tx Æ Data
Intfc1 Tx Data:
Datarate Invert (E)
Select Datarate or Invert using the W X arrow keys, then press ENTER.
(CONFIG: Intfc1 HSSI) Tx Æ Data Æ Datarate
Intfc1 Data Rate:
Tx: 032.000000 Mbps
This screen is ‘status only’ and indicates the Data Rate of the transmit MPEG-2 transport
stream. Press
ENTER or CLEAR to return to the previous menu.
(CONFIG: Intfc1 HSSI) Tx Æ Data Æ Invert
Intfc1 Tx Data Invert:
Normal Inverted (E)
To control data inversion (added for compatibility with certain older equipment), select
Normal or Inverted using the
W X arrow keys, then press ENTER.