Product specifications

CDM-710 Broadcast Satellite Modem Revision 11
Front Panel Operation MN/CDM710.IOM
5–25
(CONFIG: Intfc1 ASI) Rx ÆFrame
Intfc1 ASI Rx Frame:
188 204 ( E)
To enable the desired sync mode, select 108 or 204 using the ◄ ► arrow keys, then press
ENTER.
(CONFIG: Intfc1 ASI) Config
Intfc1 ASI CONFIG:
Port Bandwidth ( E)
Select Port or Bandwidth using the W X arrow keys, then press ENTER.
(CONFIG: Intfc1 ASI) Config Æ Port
Intfc1 ASI Port:
J4 J5 ( E)
To select the active port on the ASI Interface, select J4 or J5 using the ◄ ► arrow keys, then
press
ENTER.
Note: Also see
(CONFIG:) AUX Æ 1:1 Mode for redundancy operation.
(CONFIG: Intfc1 ASI) Config Æ Bandwidth
Intfc1 ASI Bandwidth:
Wide Narrow ( E)
To select the loop bandwidth of the ASI input, select Wide or Narrow using the ◄ ► arrow
keys, then press
ENTER.
Terrestrial jitter sometimes increases when data is sent across the Public Switched Telecom
Network (PSTN).
Wide corresponds to about 2 Hz and Narrow is approximately 0.5 Hz. Normally, the Wide
selection is adequate, but when higher amounts of terrestrial jitter are present in the incoming
ASI data stream the Narrow setting will help reduce jitter.