Product specifications

CDM-710 Broadcast Satellite Modem Revision 11
Front Panel Operation MN/CDM710.IOM
5–24
5.3.1.4 (CONFIG:) Int1 (CDI-40 ASI Interface Only)
IMPORTANT
Due to limitations of the backplane,
the CDM-710 allows only one interface to
be active. For example, if Interface 2 is active, and Interface 1 is then enabled/
selected, the unit will automatically
disable Interface 2.
Note: The menu branch and submenus depicted in this section are dependent on the presence
of the CDI-40 ASI Interface card, installable in Interface Slot 1 only.
Intfc1 ASI:
Tx Rx Config (E)
Select Tx, Rx, or Config using the W X arrow keys, then press ENTER.
(CONFIG: Intfc1 ASI) Tx
Intfc1 ASI Tx:
Ena/Dis Frame ( E)
Select Ena/Dis or Frame using the W X arrow keys, then press ENTER.
(CONFIG: Intfc1 ASI) Tx Æ Ena/Dis
Intfc1 ASI Tx:
Enable Disable ( E)
Using the W X arrow keys, select Enable to activate the Tx side of this interface, or select
Disable to de-activate the Tx side and set the Data Rate to 0. Press
ENTER when done.
(CONFIG: Intfc1 ASI) Tx Æ Frame
Intfc1 ASI Tx Frame:
188 204 ( E)
To enable the desired sync mode, select 108 or 204 using the ◄ ► arrow keys, then press
ENTER.
(CONFIG: Intfc1 ASI) Rx
Intfc1 ASI Rx:
Ena/Dis Frame ( E)
Select Ena/Dis or Frame using the W X arrow keys, then press ENTER.
(CONFIG: Intfc1 ASI) Rx Æ Ena/Dis
Intfc1 ASI Rx:
Enable Disable ( E)
Using the W X arrow keys, select Enable to activate the Rx side of this interface, or select
Disable to de-activate the Rx side and set the Data Rate to 0. Press
ENTER when done.