Product specifications

CDM-710 Broadcast Satellite Modem Revision 11
Appendix A MN/CDM710.IOM
A–43
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments for
Command or
Response to
Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to Query
Firmware
Revisions
N/A 1 byte Query only.
Query the version information of the system, where:
i = Bulk Image number (1 or 2)
a = Firmware Image
b = Firmware Revision
c = Firmware Date
Example: FRW?1
FRW?
FRW*
FRW#
FRW?i FRW={CR}Boot:{CR}a,b,c{CR}
Bulki:{CR}a,b,c{CR}a,b,c…
Gigabit Egress
FEC Enable
GEF= 2 bytes Command or Query.
Gigabit Egress FEC Enable/Disable in the form sn, where:
s=Slot (1, 2)
n=Enable / Disable, where
0 = Disabled
1 = Enabled
GEF=
GEF#
GEF?
GEF*
GEF?s GEF=sn
Gigabit Egress
Multicast Group
Address
GEG= 16 bytes Command or Query.
Gigabit Egress Multicast Group Address. The multicast stream egressing from
the gigabit interface will have this IP address as the source IP address in the
form siii.iii.iii.iii, where:
s=Slot (1, 2)
i=IP Address
GEG=
GEG#
GEG?
GEG*
GEG?s GEG=siii.iii.iii.iii
Gigabit Egress
Port Numbers
GEP= 11 bytes Command or Query.
Gigabit Egress Port Numbers in the form snnnnnppppp, where:
s=Slot (1, 2)
nnnnn = Source Port Number (0 – 65535)
ppppp = Destination Port Number (0 – 65535)
Note: Both Source Port and Destination Port must be valid for set command to
take effect.
GEP=
GEP#
GEP?
GEP*
GEP?s GEP=snnnnnppppp
Gigabit Egress
FEC Matrix
GFM= 6 bytes Command or Query.
Gigabit Egress FEC Matrix in the form sll,dd where:
s=Slot (1, 2)
ll = Length, two digit number (leading zero) between 1 and 20.
dd = Depth, two digit number (leading zero) between 4 and 20.
Note: Length x Depth, must be less than or equal to 100)
GFM=
GFM #
GFM?
GFM*
GFM?s GFM=sll,dd
Gigabit FEC
Base Port
GFP= 6 bytes Command or Query.
Gigabit FEC Base Port number in the form snnnnn, where:
s=Slot (1, 2)
n=Port Number (0 – 65535)
GFP=
GFP#
GFP?
GFP*
GFP?s GFP=snnnnn
Gigabit
Management IP
Address and
Subnet
GIP= 19 bytes Command or Query.
Gigabit Management IP address and subnet mask in the form siii.iii.iii.iii.nn,
where:
s=Slot (1, 2)
i=IP Address
n=Netmask
GIP=
GIP#
GIP?
GIP*
GIP?s GIP=siii.iii.iii.iii.nn