Product specifications

CDM-710 Broadcast Satellite Modem Revision 11
Appendix A MN/CDM710.IOM
A–26
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments for
Command or
Response to
Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to Query
Gigabit Egress
Port Numbers
GEP= 11 bytes Command or Query.
Gigabit Egress Port Numbers in the form snnnnnppppp, where:
s=Slot (1, 2)
nnnnn = Source Port Number (0 – 65535)
ppppp = Destination Port Number (0 – 65535)
Note: Both Source Port and Destination Port must be valid for set command to
take effect.
GEP=
GEP#
GEP?
GEP*
GEP?s GEP=snnnnnppppp
Gigabit Egress
FEC Matrix
GFM= 6 bytes Command or Query.
Gigabit Egress FEC Matrix in the form sll,dd where:
s=Slot (1, 2)
ll = Length, two digit number (leading zero) between 1 and 20.
dd = Depth, two digit number (leading zero) between 4 and 20.
Note: Length x Depth, must be less than or equal to 100)
GFM=
GFM #
GFM?
GFM*
GFM?s GFM=sll,dd
Gigabit
Management IP
Address and
Subnet
GIP= 19 bytes Command or Query.
Gigabit Management IP address and subnet mask in the form siii.iii.iii.iii.nn,
where:
s=Slot (1, 2)
i=IP Address
n=Netmask
GIP=
GIP#
GIP?
GIP*
GIP?s GIP=siii.iii.iii.iii.nn
Initialize Events
Pointer
IEP= None Command only.
Resets internal pointer to allow RNE? queries to start at the beginning of the
stored events log.
IEP=
IEP?
IEP*
IEP#
N/A N/A
Boot Image
IMG= 1 byte Command only.
Boot image selection, where n is the image number in the form n, where:
1=Image #1
2=Image #2
Example: IMG=1 (Image #1 selected for booting.)
IMG=
IMG?
IMG*
IMG#
IMG? IMG=n
IP Address
IPA= 18 bytes Command or Query.
Used to set the IP address and network prefix for the 10/100 BaseTx Ethernet
management port, in the form xxx.xxx.xxx.xxx.yy, where:
xxx.xxx.xxx.xxx is the IP address
yy is the network prefix (00..31)
Example: IPA=010.006.030.001.24
IPA=
IPA?
IPA*
IPA#
IPA? IPA= xxx.xxx.xxx.xxx.yy
Gateway
Address
IPG= 15 bytes Command or Query.
Used to set the Gateway IP addess for the 10/100 Base Tx Ethernet
management port, in the form xxx.xxx.xxx.xxx, where:
xxx.xxx.xxx.xxx is the IP address
Example: IPG = 010.006.030.001
IPG=
IPG?
IPG*
IPG#
IPG? IPG = xxx.xxx.xxx.xxx