Product specifications

CDM-710 Broadcast Satellite Modem Revision 11
Appendix A MN/CDM710.IOM
A–19
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments for
Command or
Response to
Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to Query
Tx Spectrum
Invert
TSI= 1 byte Command or Query.
Tx Spectrum Invert selection in the form x, where:
0=Normal
1=Tx Spectrum Inverted
Example: TSI=0 (normal SI selected)
TSI=
TSI?
TSI*
TSI#
TSI? TSI=x
Unit Test Mode
TST= 1 byte Command or Query.
Test Mode in the form x, where:
0=Normal Mode (no test)
1=IF Loop
2=I/O Loop
3=RF Loop
4=Tx CW
5=Tx Alternating 1,0 Pattern
Example: TST=4 (Tx CW)
TST=
TST?
TST*
TST#
TST? TST=x
Tx Transport
Mode
TTM= 1 byte Command or Query.
Sets the transport mode for DVB-S2 mode.
0 = Generic Mode
1 = Transport Stream (Default)
Note: Command applies only with DVB-S2 and HSSI. For any other mode, set
TTM to 1
Example: TTM=1 (Transport Mode selected)
TTM= TTM?
TTM*
TTM#
TTM? TTM=x
Tx Carrier State
TXO= 1 byte Command or Query.
Tx Carrier State in the form x, where:
0=OFF due to front panel or remote control command
1=ON
Example: TXO=1 (Tx Carrier ON)
TXO=
TXO?
TXO*
TXO#
TXO? TXO=x