Product specifications

CDM-710 Broadcast Satellite Modem Revision 11
Appendix A MN/CDM710.IOM
A–11
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments for
Command or
Response to
Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to Query
Faults and
Status (cont.)
C= Reserved
D= ASI Port Transmit Data Loss (Interface 1)
E= Reserved
F= ASI Frame Not Synchronized (Interface 1)
G= Reserved
H= HSSI TX Clock Failure (Interface 1)
I= Reserved
J= GBEI Card Datarate > + 200 PPM
K= GBEI Card Datarate < - 200 PPM
L= GBEI No PHY Link
M= Encoder FIFO Empty
N= Encoder FIFO Full
O= ASI Tx Input Datarate Offset > +110PPM (Interface 1)
P= Reserved
Q= ASI Tx Input Datarate Offset < -110PPM (Interface 1)
R= Reserved
S= SERDES Parity Errors
c=Rx Traffic Status
0=No faults
d=New Faults
0=No new faults
1=New faults, since last check
Firmware
Revisions
N/A 1 byte Query only.
Query the version information of the system. Where:
i = Bulk Image number (1 or 2)
a = Firmware Image
b = Firmware Revision
c = Firmware Date
Example: FRW?1
FRW?
FRW*
FRW#
FRW?i FRW={CR}Boot:{CR}a,b,c{CR}
Bulki:{CR}a,b,c{CR}a,b,c…
Gigabit FEC
Enable
GFE= 2 bytes Command or Query.
Enables the Gigabit FEC mode in the form sn, where:
s=Slot (1, 2)
n=Enable/Disable
0=Disabled
1=Enabled
GFE=
GFE#
GFE?
GFE*
GFE?s GFE=sn
Gigabit FEC
Base Port
GFP= 6 bytes Command or Query.
Gigabit FEC Base Port number in the form snnnnn, where:
s=Slot (1, 2)
n=Port Number (0 – 65535)
GFP=
GFP#
GFP?
GFP*
GFP?s GFP=snnnnn