Product specifications

CDD-880 Multi Receiver Router Revision 0
Ethernet Management MN-CDD880
5–27
Set Time (hh:mm:ss) – Enter a time using HH:MM:SS format (where HH = hour [00 to 23],
MM = minutes [00 to 59], and SS = seconds [00 to 59]).
Set Date (dd/mm/yy) – Enter a date using the European time format DD/MM/YY (where
DD = day [01 to 31], MM = month [01 to 12], and YY = year [00 to 99]).
Click [Submit] once the desired changes have been made for the time and date.
Adjustment for Internal 10 MHz Reference – Enter a value from -999 to (+)999, then click
[Submit] as needed to save this setting.
Save/Load Configuration
This section allows the user to save, then load (recall) up to 10 configuration sets.
To save a configuration set: After all configuration parameters have been adjusted to suit, use the
top (Save) Select Location dropdown to select 0 through 9, then click [Save Configuration] as
needed to store the specified configuration settings.
To load (recall) a configuration set: Use the bottom (Load) Select Location dropdown to select 0
through 9, then click [Load Configuration] as needed to recall the selected configuration
settings.
BERT
(Where BERT is the acronym for Bit Error Rate Test)
Bert Config – Using the drop-down menus:
Select the Rx BERT State as On or Off;
Select the Rx BERT Pattern as 2^23-1 (2
23
-1) or 2047;
Once the desired BERT settings have been entered in this section, click [Submit] as needed to
save and execute these changes.
Bert Monitor – This read-only section displays the ongoing BERT. Click [Restart] to restart the
BERT Monitor, or [Update] to refresh a test already in progress.