Product specifications

CDD-880 Multi Receiver Router Revision 0
Ethernet Management MN-CDD880
5–12
5.4.4.4 Configuration Pages
The ‘Configuration’ pages are used to configure all router parameters. Click the Interface,
Demod, ARP, or Routing tab to continue (the ‘Configuration | LNB’ page is inoperable at this
time).
5.4.4.4.1 Configuration | Interface
Click the FE Mgt or GE tab to continue.
5.4.4.4.1.1 Configuration | Interface | FE Mgt
Figure 5-8. Configuration | Interface | FE Mgt page
The ‘Configuration | Interface | FE Mgt’ page (Figure 5-8) perm
its the user to configure the
10/100 BaseT Fast Ethernet (FE) Management (M&C) port.
FE – Management Interface
MAC Address – This parameter is read-only and cannot be changed.
IP Address / CIDR Mask – Enter the IP Address
and CIDR (Classless Inter-Domain Routing)
Subnet Mask using this box (the Subnet Mask valid range is from 8 – 30).
Link Configuration – Use the drop-down menu to select the line speed and duplex setting for the
CDD-880’
s FE interface. The available options are:
• Auto • 100 BaseT / Full Duplex • 10 BaseT / Full Duplex
• 1000 BaseT / Full Duplex
(GigE only)
• 100 BaseT / Half Duplex • 10 BaseT / Half Duplex
Note: If the configuration of the port is unknown, then “Auto” is the recommended configuration.