Product specifications

CDD-880 Multi Receiver Router Revision 1
Rear Panel Connections MN-CDD880
3–11
3.3.2.2 AC Operation – Replacing Fuses

FOR CONTINUED OPERATOR SAFETY, ALWAYS REPLACE THE FUSES WITH THE
CORRECTTYPEANDRATING.

TheCDD‐880usestwo20mmSlow‐blowfuses–oneeachforlineandneutralconnections.The
fusesarelocatedintherearpanelatthepowersupply(Figure3‐7).

DISCONNECTTHEPOWERSUPPLYBEFOREPROCEEDING!

The fuses are contained within a fuse holder that is press‐fit into the body of the IEC
powermodule.












Figure 3-7. Replacing CDD-880 AC Fuses

Toreplacethefuses:

• First,unseatthefuseholderfromtheIECpowermodule.

o UsetheslottoprytheholderoutwardfromtheIECpowermodule.

o Pulltheholderstraightout,andthenswingthehold erawayfromthemodule.

• Then,removeandreplacethefusesasneede
d.

o UseT3.15(3.15Amp)fusesforstandardrouteroperation.

• Finally,re‐seatthefuseholderintheIECpowermodule.

