User Guide

15
15. Attach the headband cable to the clips on the headband.
16. Connect the microphone cable to the left earcup.
12. STORAGE AND DISPOSAL
12.1. STORAGE
• Clean the headset before storage.
• Examine the headset for wear or damage.
• Keep the headset in a clean and dry area within a
temperature range of: -20°C/-4°F to 50°C/122°F.
• Do not store the headset in direct sunlight.
• During long term storage, remove the batteries from the
battery compartment.
12.2. DISPOSAL
• Obey national regulations.
• To properly dispose of the battery, follow local solid waste
disposal regulations.
• Use the local recycling system for electronic equipment.
12.2.1. BATTERY DISPOSAL
Many rechargeable batteries are required to be recycled by
local, state/province, and national laws. To properly recycle/
dispose of the battery or battery pack, always follow local
solid waste disposal regulations.
EN
13. MAINTENANCE
13.1. TO CLEAN AND MAINTAIN THE HEADSET
• Use a cloth wetted with soap and warm water to clean the
outer shells, headband and ear cushions.
• If the headset gets wet from rain or sweat, remove the ear
cushions and foam liners, and allow to dry before
reassembly. Refer to “13.2. To remove and replace the
hygiene kit”.
Note: This headset is designed to withstand brief, shallow
water immersion, including saltwater. Following water
exposure and immersion, the headset should be dried using
the instructions listed above. Once dry, the user should
perform a visual inspection and perform a functions test. If the
visual inspection reveals salt crystal formation, the headset
should be quickly rinsed with fresh water and allowed to dry.
• Examine the ear cushions and foam liners regularly for
damage. Ensure there are no cuts or tears and that the
foam or gel cushions respond when compressed. After
long use or improper storage, the ear cushions may
become compressed and will no longer form a seal around
the ear. A damaged ear cushion or foam liner must be
replaced. Refer to “14. Accessories”.
• Replace the foam liners and ear cushions a minimum of
twice a year and as needed.
Note: The environmental microphone windscreen serves a
critical function in reducing wind noise that can interfere with
environmental microphone performance.
• Replace environmental/ambient microphone windscreens
when torn or missing.
13.2. TO REMOVE AND REPLACE THE HYGIENE KIT
1. Hold the inner edge of the ear cushion and pull it straight
out.
2. Remove the old ear cushion.
3. Remove the foam liner.
4. Put the new foam liner into the earcup.
5. Align the new ear cushion with the earcup.
EN