USER MANUAL USB Bluetooth Adapter UBT-120
CONTENT 1. Introduction--------------------------------------------------------------------------------- 2 2. Package Content------------------------------------------------------------------------- 2 3. Product Features------------------------------------------------------------------------- 2 4. System Requirements------------------------------------------------------------------ 3 5. Driver Installation ----------------------------------------------------------------- 3 5.1 5.
1. Introduction The Comsol Bluetooth Adapter is a quick and easy solution for users wanting to add Bluetooth capability to their desktop or notebook. It plugs directly into your USB port of your computer and enables wireless connectivity with Bluetooth devices including mobile phones, PDAs, printers and other computers.
. System Requirements PC IBM® PC Pentium 133 or higher or compatible system Available USB2.0 port (up to 480 Mbps) or available USB1.1 port (up to 12Mbps) Windows® 98, Windows® ME, Windows® 2000 and Windows® XP 5. Driver Installation 5.1 Windows® 98SE/ME/2000/XP Driver Installation DO NOT INSERT THE BLUETOOTH ADAPTER BEFORE FOLLOWING THESE INSTRUCTIONS 5.1.1 Insert the supplied CD disk into the CD-ROM drive. 5.1.2 The CD will auto-run and the Setup screen will appear. Click Next to proceed.
.1.3 Select “I accept …” to enable installation of the software and click Next. 5.1.4 NOTE: Depending on the OS installed, this screen may not appear during initial installation.
Choose the destination folder for installation and click Next. 5.1.5 Click Install to confirm installation of the software.
5.1.6 Click OK to disable unsigned driver warnings and proceed with the installation. 5.1.7 PLEASE DO NOT CONNECT THE COMSOL USB BLUETOOTH ADAPTER Click Cancel to continue installation without the Bluetooth device.
5.1.8 When installation is completed, follow the instructions to reboot the system. 5.1.9 Insert the Comsol USB Bluetooth Adapter into an available USB port of the PC after the software installation is complete and the system has rebooted. After the Comsol Bluetooth Adapter is inserted, the Found New Hardware Wizard will pop up. Follow the on-screen instructions to install the driver.
5.1.10 After completion of the driver installation, an icon will show up at the lower-right corner of the desktop, announcing the availability of the new hardware.
5.2 Win98SE platform 5.2.1 5.2.2 When installing, it would request the Win98 CD as below. Click “OK”. 5.2.3 And then the dialog would appear, Click “Cancel”. 5.2.4 Then wait the installation finished, and reboot the system. If Windows booted, insert the dongle. The driver would auto-loaded.
6. Bluetooth Logo Conditions 6.1 Condition 1: Disconnection of the Bluetooth Network (The Bluetooth Network is disconnected while the Bluetooth dongle is still plugged in and the software is under operation.) 6.2 Condition 2: Failure to detect the Bluetooth dongle (The Bluetooth icon turns red, indicating the failure to detect the Bluetooth dongle.) 6.3 Condition 3: Availability of the Bluetooth dongle (The Bluetooth icon turns white, indicating the availability of the Bluetooth dongle.
7. FCC Statement This device generates and uses radio frequency and may cause interference to radio and television reception if not installed and used properly. This has been tested and found to comply with the limits of a Class B computing device in accordance with the specifications in Part 15 of FCC Rules. These specifications are designed to provide reasonable protection against such interference in a residential installation.
