User Manual

9
5. Operation Instructions
Use the preservation tank or the preservation box for
vacuum package
1. Wipe the preservation tank or box and cover clean, and keep it dry.
2. Put the goods into the preservation tank or box without being too full. Put on
the cover.
3. Insert the air inlet and the extraction opening on the preservation tank or box
cover on two ends of the extraction pipe to ensure the preservation tank or box at
a sealing status. See Fig. 5.
4. Press on the vacuum sealing button. When the vacuum pressure is adequate,
this machine will automatically stop working. See Fig. 6.
5. Immediately take off the extraction pipe after vacuuming.
Open the Preservation Tank or Box
Press on the “Discharge“ button on the cover of the preservation tank or box.
(Different operation modes for different vessels.)
Notes
 Cool down this machine for 1 minute after every packaging so as to achieve better
sealing effects. Clean away extra liquids or chemicals remaining in the vacuum
chamber for the next sealing.
 In order to prevent excessive heating of the sealing heating stripe upon sustainable
sealing, press on the “single sealing” button, and this machine will stop working for
18 seconds and then resume to its normal operating status.
 This machine can only provide vacuum packaging for the specialized packaging bag.
If there is no specialized packaging bag, it cannot be used for vacuum packaging.
 During vacuum packaging of the preservation tank or box, the heating stripe will be
very hot, which might cause scalds to you if touching on it.
 The vacuum bag shall not be filled with too many goods. Otherwise, the sealing
might not be flat. The overlapped part of the sealing might have cracks and leakage.
Fig. 6
Fig. 5