Manual

Stac IP address
Opal is shipped from the factory set to DHCP mode, so it will nd an address on your network if possible. The easiest way to nd what
that address is to use the Comrex Device Manager ulity, available on our website for both Windows and Mac plaorms. You can also
use Device Manager to upgrade the rmware on your Opal.
Install Device Manager on a computer on the same physical LAN as the Opal. Once installed and run, press the “Scan” buon in the upper
le corner to scan your network for Comrex products. The results should look like this:
There are two ways to set the stac IP informaon using Device Manager. The “rescue” mode allows you to change parameters during
the rst ve minutes of operaon, and is iniated using the “Network Sengs” buon on the right pane. This mode is most useful if
you’ve forgoen the unit password. The normal mode of changing any sengs in Opal is by clicking the “Web Conguraon” tab in the
right pane. This opens the unit’s Toolbox interface. Toolbox is a web-based interface that allows you to set all relevant parameters of the
product. Once you know the unit’s IP address, Toolbox can also be accessed via a browser by going to hp://[ip-address]/cfg. Toolbox
requires that you log on with a username and password. The default user name is “ admin ” and the default password is “ comrex ”. We
recommend you change the default password. Once logged in, choose the “Network” opon. Under “Network Mode”, you’ll see the
following opons:
7