Manual


Setup for  is done enrely on the end of the link that has dual networks connected. On the BRIC-Link II,
the best way to set up  is via the  page, accessible via the web based interface. Navigate
to the three-line Main Menu icon in the upper le hand corner of the screen and select Network Manager.
Before entering the Network Manager, the secondary network should be aached to the BRIC-Link II via USB. The
default behavior for CrossLock is to use all networks available to aggregate and apporon data based on capacity
and delay calculaons. To congure primary and secondary networks, this behavior will require changes in the
Network Manager.
In Network Manager, a list of all networks aached to the codec and their status will populate under “Select
Network Device,” as shown in Figure 68.

Here the backup network can be selected. This network’s opons can be expanded using the “”
buon, which will reveal addional conguraon opons. Find the opon labelled “Use with CrossLock” and
change the default from “yes” to “backup” (Figure 69).


Select “Save Sengs”, then click “Close” or press ESC to exit Network Manager.
94