Manual

23


Since the Ethernet sengs are made with a web connecon, keying in incorrect stac IP informaon can result in
losing access to the interface enrely. If this happens, it is possible to be “locked out” of the unit
(i.e., unable to log in).  has a network recovery tool to help with this: .
For security reasons,  is only available during  aer a BRIC-Link II
unit has (re)booted. Once those ve minutes have elapsed, the unit will need to be rebooted in order to perform
network recovery.
10 shows  . The “” buon has shown the presence of a BRIC-Link II on the
network. On the “” tab on the right pane, the “” buon is acvated and a countdown mer
is started. Selecng this will allow changing of the primary Ethernet sengs in the same way as Toolbox.
Once the IP address is setup via the , the rest of the setup and operaon of the BRIC-Link II is done
via the . This process is addressed in the following secon.
3
1
2