Manual

21

Generally, it is recommended to congure the Ethernet port of an BRIC-Link II for a stac IP. This will facilitate
access to the  with a browser and allow for easier conguraon of routers or rewalls (if
necessary). If the BRIC-Link II is to be installed on a managed LAN, Comrex recommends consulng with the IT
services provider about obtaining a stac IP address.
As menoned in the previous secon, the BRIC-Link II is congured for by default. This means that it tries to
extract an unused IP address from the network router upon boong. To change the Ethernet IP addressing to ,
select the “” locaon at the boom of the list and change the “” to . The system will prompt a
list of stac sengs as shown in  (on the following page).
As can be seen in the stac IP address, the Netmask, the Gateway Address, and at least one DNS Server
Address must be congured in the proper elds to set a stac IP address. Once that informaon has been input,
click the “” buon and select  to have the BRIC-Link II accept and acvate the new Ethernet
sengs. Note that if the IP sengs of the Ethernet port have been changed, the connecon to the 
interface will no longer work. Click the “” buon on  to re-sync with the new IP address.