Manual

Selecng  here will open the conguraon pop-up.

For Ethernet, it’s recommended to leave the default network as-is (DHCP) for tesng and upgrades, and to add stac

networks as addional . To do this, select the arrow to the le of “” to expand the Locaon

list. You can then choose “”.

You’ll then be able to select the new locaon, rename it, and apply the required informaon to use the Ethernet Port at

the new locaon. The informaon required is:

• IP Address

• IP Netmask

• IP Gateway Address

• IP DNS (Primary and Secondary)

Once these are programmed and saved, choose the “” opon to change to the chosen Ethernet

sengs and back whenever required.



When the included Wi-Fi adapter is aached to one of the USB ports, a network entry of “” will appear.

Selecng it will show the status, current IP address, MAC Address of the adapter, and network chosen (if any). The MAC

Address of the WLAN adapter is dierent than the MAC Address of the NX Portable’s Ethernet Port. This WLAN MAC

Address is oen necessary for Port Forwarding and Whitelisng the NX Portable when connected to Wi-Fi Networks.