User's Manual

50D0096 Rev 0 Aug 2005 Page 5 of 10 Ambient Technologies
A Division Of
Monessen Hearth Systems
Setting Privacy (DIP) Switch on Receiver and Transmitter:
The remote receiver and transmitter privacy (DIP) switches are preset at the factory. In the event of activation or
interference from other nearby transmissions, reset the code using the following procedure:
1. Slide the code switches on the transmitter and receiver to your choice of ON or OFF position. Switches
#1, #2, #3 and #4 are preset to “ON” for both the transmitter and receiver.
2. The switches on the transmitter and receiver must match in order for the system to work.
3. To check, press either the On or Off button on the transmitter and the receiver indicator light will blink. If
not repeat step 2.
4. The system is now ready to operate.
NOTE See optional auto shutdown on page 8 of 10.
ON
DIP
ON
DIP
WARNING
Do not use two (2) or more remote control systems in the same area with the same dip switch
settings, as they will communicate with each other. This may cause the appliances to
malfunction.
Reset Button:
1. The reset button can be used to reset the transmitter if transmitter is not working properly. The reset
button is located behind the battery door cover in the lower left corner of battery comparment. Using a
paper clip, press the reset button and the transmitter will reset and initialize for 10 seconds before it can be
used.
Receiver
Dip Switch (Default)
Transmitter